[Info] Some advices for the Cold Fusion Reactors builders...

Dear All,

For those want to replicate the Cold Fusion Reactor, I give you some advices :

- Use a pyrex or a borosilicate vessel ( i.e. used for making coffee ),
- Use a
DC Power Supply which is able to give about 200 V DC at 10 A ( don't use AC voltage ), see the power supply diagram that I use ( here ),
- Don't use too much electrolyte solution, 0.6 L is the maximum for a small 2 mm diam tungsten rod. a 0.2 Liter solution is the best.

For the Potassium Carbonate ( K2CO3 ) :
The weight of 1 Mole is 138.2 g. If you want to have a 0.2 molar solution ( 0.2 M or 0.2 mole/L ).
For 0.2 Liter, you need to add : 0.2 * 138.2 * 0.2 = 5.5 g of K2CO3

For the Sodium Hydrogenocarbonate ( NaHCO3 ) ( Baking Soda ) :
The weight of 1 Mole is 84 g. If you want to have a 0.2 molar solution ( 0.2 M ).
For 0.2 Liter, you need to add : 0.2 * 84 * 0.2 = 3.4 g of NaHCO3.

- Use a LOW molarity, 0.2 M is the best. If you connect your CFR directly to the power grid through a DC bridge rectifier. Use only a 0.2 molar solution, this will avoid to broke your fuse...
- BE CAREFULL, don't forget to disconnect your CFR from the power grid line BEFORE touch it...
- Do your experiment in a
well ventiled room,
- I recommend you strongly to read carefully the document about the Mizuno experiment and wrote by Eugene Mallove at :
http://www.amasci.com/weird/anode.txt , you will find in this paper some very helpfull advices.

Good CFR experiment, I shall be glad if you could sent me some photos of your working Cold Fusion Reactor.

Best Regards
Jean-Louis Naudin

Disclaimer : The author assumes no liability for any incidental, consequential or other liability from the use of this information. All risks and damages, incidental or otherwise, arising from the use or misuse of the information contained herein are entirely the responsibility of the user. Although careful precaution has been taken in the preparation of this material. Be Carefull, you must conduct this test in a well ventiled room or better in open air, you must not smoke during the test. This experiment is not intended for the inexperienced. User of this document should be very carefull to try anything out ! If you do it, the risk of any results is just yours. I take no responsibility of anything that might happen, let it be of a wrong information or anything else.

Return to the CFR Experimenter's corners page